Ford Fusion: Engine Emission Control - 1.5L EcoBoost (118kW/160PS) – I4 / Positive Crankcase Ventilation (PCV) Valve. Removal and Installation

Crankcase Vent Oil Separator. Removal and Installation

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal NOTE: Removal steps in this procedure may contain installation details...

Intake Air Distribution and Filtering - 1.5L EcoBoost (118kW/160PS) – I4

..

Other information:

Ford Fusion 2013–2020 Service Manual: Interior Rear Door Handle. Removal and Installation

Removal NOTE: LH side shown, RH side similar. Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the retainers and remove the interior front door handle. NOTE: This step is only necessary when installing a new component. Remove the door lock c..

Ford Fusion 2013–2020 Service Manual: Module Programming. General Procedures

Check NOTE: Perform the following pre-checks to make sure module programming completes without errors. NOTE: Starting the engine prior to creating a programming session may prevent certain part number information from being inhaled by the IDS. This may cause programming errors in some modules. Start the programming session in Key ON Engine OFF. Make sure the vehicle ..