Ford Fusion: Multifunction Electronic Modules / Module Controlled Functions - Component Location. Description and Operation

Multifunction Electronic Modules

..

Module Controlled Functions - Overview. Description and Operation

Body Control Module (BCM) The BCM controls the following: Battery saver function Brake shift interlock Delayed accessory function Dimmable backlighting Decklid release Exterior lighting Horn Ignition state messaging Push-button start function Interior lighting Key validation (part of the PATS) Keyless entry keypad PATS ..

Other information:

Ford Fusion 2013–2020 Service Manual: Piston Inspection. General Procedures

Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod. NOTE: Make sure the oil ring hol..

Ford Fusion 2013–2020 Service Manual: Wire Terminal Inspection and Removal. General Procedures

Disconnect   WARNING: Before beginning any service procedure in this section, refer to Health and Safety Precautions in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury. Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation). NOTE: To avoid wiring pin (terminal) dama..