Ford Fusion: Service Information / Identification Codes

Ford Fusion 2013–2020 Service Manual / General Information / Service Information / Identification Codes

Identification Codes. Description and Operation

Wire Terminal Inspection and Removal. General Procedures

Disconnect WARNING: Before beginning any service procedure in this section, refer to Health and Safety Precautions in section 100-00 General Information...

Identification Codes. Description and Operation

Vehicle Identification Number (VIN) VIN Locator The VIN is a 17-digit combination of letters and numbers. The VIN is stamped on a metal tab riveted to the instrument panel, top upper left of the dash...

Other information:

Ford Fusion 2013–2020 Service Manual: Keyless Entry Rear Antenna. Removal and Installation

Removal Open the luggage compartment lid. Release the clips and remove the liftgate scuff plate trim panel. Disconnect the keyless entry rear antenna electrical connector and remove the keyless entry rear antenna...

Ford Fusion 2013–2020 Service Manual: Stoplamp Switch. Removal and Installation

Removal NOTICE: Do not press, pull or otherwise move the brake pedal while removing or installing the stoplamp switch. The switch must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position...

Understanding Your Tire Pressure Monitoring System

Ford Fusion. Understanding Your Tire Pressure Monitoring System

The tire pressure monitoring system measures pressure in your road tires and sends the tire pressure readings to your vehicle. You can view the tire pressure readings through the information display. The low tire pressure warning light will turn on if the tire pressure is significantly low. Once the light is illuminated, your tires are under-inflated and need to be inflated to the manufacturer’s recommended tire pressure. Even if the light turns on and a short time later turns off, your tire pressure still needs to be checked.