Ford Fusion: Brake System / Hydraulic Brake Actuation

Parking Brake Switch. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

Brake Fluid Reservoir. Removal and Installation

Materials Name Specification Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake FluidPM-20 WSS-M6C65-A2  Removal NOTICE: If the brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water...

Other information:

Ford Fusion 2013–2020 Service Manual: Front Fog Lamp. Removal and Installation

Removal Remove the fog lamp bezel. Remove the screws and the fog lamp. Disconnect the electrical connector. Installation To install, reverse the removal procedure. Adjust the foglamp assembly...

Ford Fusion 2013–2020 Service Manual: Piston Inspection. General Procedures

Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod...