Ford Fusion Manuals

Ford Fusion: Engine System - General Information / Engine - Overview. Description and Operation

Engine Information

NOTE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.

NOTE: Specifications show the expected minimum or maximum condition. Refer to the appropriate section in Group 303 for the specifications.

NOTE: If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.

NOTE: This section contains information, steps and procedures that may not be specific to this engine.

This section covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the PC/ED manual.

The engine incorporates the following features: Refer to the appropriate section in Group 303 for the procedure.

  • Crankcase ventilation or breather system
  • Exhaust emission control system
  • EVAP

Some engines incorporate a fail-safe cooling system. Refer to the appropriate section in Group 303 for the procedure.

The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the Scheduled Maintenance Guide.

Correct engine identification is required to order parts. Refer to the appropriate section in Group 303 for the procedure.

For complete vehicle and engine identification codes,
Refer to: Identification Codes (100-01 Identification Codes, Description and Operation).

    Specifications

    ..

    Engine. Diagnosis and Testing

    Inspection and Verification - Engine Performance NOTE: There are 2 diagnostic paths that can be followed depending on the type of engine concern. Carry out Inspection and Verification - Engine Performance or Inspection and Verification - NVH...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Climate Control Housing - Vehicles With: Electronic Manual Temperature Control (EMTC). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel upper section. Refer to: Instrument Panel Upper Section (501-12 Instrument Panel and Console, Removal and Installation). Detach the wiring harness retainer, remove the nuts and the instrument panel upper brace...

    Ford Fusion 2013–2020 Service Manual: Gear Shift Module (GSM). Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: It is not necessary to carry out a PMI when installing a new GSM unless specifically instructed to do so in a TSB, GSB, FSA or SSM. NOTE: Removal steps in this procedure may contain installation details...

    Categories

    Power Door Locks

    The power door lock control is on the driver and front passenger door panels.

    Ford Fusion. Power Door Locks

    Unlock. Lock.

    read more

    Copyright © 2025 www.fofusion2.com