Ford Fusion: Electronic Engine Controls - 1.5L EcoBoost (118kW/160PS) – I4 / Crankshaft Position (CKP) Sensor. Removal and Installation

Ford Fusion 2013–2020 Service Manual / Powertrain / Engine / Electronic Engine Controls - 1.5L EcoBoost (118kW/160PS) – I4 / Crankshaft Position (CKP) Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in N, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

Remove the retainers and the engine undershield.

Ford Fusion. Crankshaft Position (CKP) Sensor. Removal and Installation

1. Disconnect the CKP sensor electrical connector.
1. Remove the bolt.
  Torque: 89 lb.in (10 Nm)
1. Remove the CKP sensor.

Installation

To install, reverse the removal procedure.

After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.

Charge Air Cooler Coolant Temperature (CACCT) Sensor. Removal and Installation

Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2 Removal NOTE: Removal steps in this procedure may contain installation details...

Cylinder Head Temperature (CHT) Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe (303-12A Intake Air Distribution and Filtering - 1...

Other information:

Ford Fusion 2013–2020 Service Manual: Front Seats - System Operation and Component Description. Description and Operation

System Operation System Diagram - Memory Seat Item Description 1 Memory Power Seat Motors 2 HS1-CAN 3 PCM 4 BCM 5 HS1-CAN 6 Ignition Switch 7 GWM 8 Memory SET Switch 9 Driver Seat Control Switch 10 MS-CAN 11 DSM 12 MS-CAN 13 DDM 14 Position Sensors 15 Motors Network Message C..

Ford Fusion 2013–2020 Service Manual: Power Transfer Unit. Removal

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). If equipped. Remove the underbody shield. Remove the rear driveshaft. Refer to: Rear Driveshaft (205-01 Driveshaft, Removal and Installation). Loosen the clamp, remove the nuts a..

Fuel Quality

Choosing the Right Fuel

Ford Fusion. Fuel Quality

Your vehicle is designed to operate on regular unleaded gasoline with a minimum pump (R+M)/2 octane rating of 87.