Ford Fusion Manuals

Ford Fusion: General Information / Brake and Clutch Systems Health and Safety Precautions. Description and Operation

Ford Fusion 2013–2020 Service Manual / General Information / Service Information / General Information / Brake and Clutch Systems Health and Safety Precautions. Description and Operation

Ford Fusion. Brake and Clutch Systems Health and Safety Precautions. Description and Operation  WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.

Ford Fusion. Brake and Clutch Systems Health and Safety Precautions. Description and Operation  WARNING: Do not breathe dust or use compressed air to blow dust from storage containers or friction components. Remove dust using government-approved techniques. Friction component dust may be a cancer and lung disease hazard. Exposure to potentially hazardous components may occur if dusts are created during repair of friction components, such as brake pads and clutch discs. Exposure may also cause irritation to skin, eyes and respiratory tract, and may cause allergic reactions and/or may lead to other chronic health effects. If irritation persists, seek medical attention or advice. Failure to follow these instructions may result in serious personal injury.

NOTICE: If the brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

    Battery and Battery Charging Health and Safety Precautions. Description and Operation

      WARNING: Batteries contain sulfuric acid and produce explosive gases. Work in a well-ventilated area. Do not allow the battery to come in contact with flames, sparks or burning substances...

    Engine Cooling System Health and Safety Precautions. Description and Operation

      WARNING: Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Instrument Panel and Interior Switches Illumination. Diagnosis and Testing


    DTC Charts Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   BCM DTC Chart   DTC Description Action B1315:11 Backlighting (Non Reflective Controls) Illumination Output: Circuit ..

    Ford Fusion 2013–2020 Service Manual: Cylinder Bore Taper. General Procedures


    Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. If the cylinder bore taper does not meet specification, bore the cylinder to the next oversize lim..

    Categories

    Fuel Quality

    Choosing the Right Fuel

    Ford Fusion. Fuel Quality

    Your vehicle is designed to operate on regular unleaded gasoline with a minimum pump (R+M)/2 octane rating of 87.

    read more

    Copyright © 2026 www.fofusion2.com