Ford Fusion Manuals

Ford Fusion: Side and Rear Vision / Blind Spot Information System - Overview. Description and Operation

Ford Fusion 2013–2020 Service Manual / Electrical / Electronic Feature Group / Side and Rear Vision / Blind Spot Information System - Overview. Description and Operation

Overview

BLIS®

The BLIS® aids the driver in assessing whether another vehicle is present within a specific area (blind spot) to either side of the vehicle, extending rearward approximately 6 m (20 ft) beyond the rear bumper while driving on roads and highways. The system is not designed to prevent contact with other vehicles or objects. The BLIS® uses the exterior mirror BLIS®/ CTA Light Emitting Diodes (LEDs) to alert the driver that a vehicle has been detected. The BLIS® provides alerts to the driver when the vehicle is in a forward gear and the vehicle speed is greater than 10 km/h (6 mph).

CTA

When the vehicle is in REVERSE (R), the CTA system alerts the driver of vehicles that are approaching from the side when backing out of a front-in parking space or backing towards the road. The system can detect a vehicle approaching from 14 m (45 ft) away at a speed up to 60 km/h (37 mph) from the left or right side of the vehicle. The CTA system uses the exterior mirror BLIS®/ CTA Light Emitting Diodes (LEDs), a warning chime from the audio speakers and a message in the IPC message center to notify the driver of approaching vehicles.

NOTE: If a MyKey® restricted key is in use, the BLIS® and CTA system automatically set to on and cannot be turned off through the IPC.

    Blind Spot Information System - Component Location. Description and Operation

    C..

    Blind Spot Information System - System Operation and Component Description. Description and Operation

    System Operation BLIS® and CTA System Diagram Item Description 1 SODR 2 GWM 3 IPC 4 PCM 5 SODL 6 DDM 7 PDM 8 BCM 9 PAM 10 LH exterior mirror 11 LH BLIS®/ CTA LED 12 RH exterior mirror 13 RH BLIS®/ CTA LED 14 ACM 15 With..

    Other information:

    Ford Fusion 2013–2020 Service Manual: Autolamps. Diagnosis and Testing


    DTC Chart: BCM Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   BCM DTC Chart DTC Description Action B1A85:11 Ambient Light Sensor: Circuit Short To Ground   GO to Pinp..

    Ford Fusion 2013–2020 Service Manual: Quick Release Coupling. General Procedures


    Disconnect NOTE: When reusing liquid or vapor tube connections, make sure to use compressed air to remove any foreign material from the connector retaining clip area before separating from the tube or damage to the tube or connector retaining clip may occur. NOTE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cl..

    Categories

    Direction Indicators. Interior Lamps

    Direction Indicators

    Ford Fusion. Direction Indicators. Interior Lamps

    Push the lever up or down to use the direction indicators.

    read more

    Copyright © 2022 www.fofusion2.com