Ford Fusion: Automatic High Beam Control / Automatic High Beam Control Indicators. Overriding Automatic High Beam
Control
Automatic High Beam Control Indicators
The indicator illuminates to
confirm when the system is
ready to assist.
Overriding Automatic High Beam Control
WARNING: The system does not
relieve you of your responsibility to drive
with due care and attention. You may
need to override the system if it does not
turn the high beams on or off.
WARNING: You may need to
override the system when approaching
other road users.
WARNING: You may need to
override the system during inclement
weather.

Push the lever away from you to switch
between high beam and low beam.
What Is Automatic High Beam Control
The system turns on high beams if it is dark
enough and no other traffic is present. If it
detects an approaching vehicle’s
headlamps or tail lamps, or street lighting
ahead, the system turns the high beams
off...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Climate Control System Health and Safety Precautions (100-00 General Informat..
Inspection
NOTE:
Procedure 1 — Ambient Temperature below 21 °C (70 °F).
NOTE:
Proper A/C system diagnosis on a vehicle’s
compressor is dependent on correct refrigerant system charge and tested
in ambient temperatures above 21°C (70°F). Perform the following steps
to achieve normal operating pressures.
Drive the vehicle or run the engine until it reaches normal operati..