Ford Fusion Manuals

Ford Fusion: Brakes / Hill Start Assist

WARNING: The system does not replace the parking brake. When you leave your vehicle, always apply the parking brake.

WARNING: You must remain in your vehicle when the system turns on. At all times, you are responsible for controlling your vehicle, supervising the system and intervening, if required. Failure to take care may result in the loss of control of your vehicle, serious personal injury or death.

WARNING: The system turns off if there is a malfunction or if you excessively rev the engine.

The system makes it easier to pull away when your vehicle is on a slope without the need to use the parking brake.

When the system is active, your vehicle remains stationary on the slope for two to three seconds after you release the brake pedal. This allows time to move your foot from the brake to the accelerator pedal. The system releases the brakes automatically once the engine has developed sufficient drive to prevent your vehicle from rolling down the slope. This is an advantage when pulling away on a slope, for example from a car park ramp, traffic lights or when reversing uphill into a parking space.

Note: The system only functions when you bring your vehicle to a complete standstill. Shift the gearshift lever to reverse (R) when facing downhill and first gear (1) when facing uphill.

Note: There is no warning light to indicate the system is either on or off.

Using Hill Start Assist

  1. Press the brake pedal to bring your vehicle to a complete standstill. Keep the brake pedal pressed.
  2. If the sensors detect that your vehicle is on a slope, the system activates automatically.
  3. When you remove your foot from the brake pedal, your vehicle remains on the slope without rolling away for about two to three seconds. This hold time automatically extends if you are in the process of driving off.
  4. Drive off in the normal manner. The system releases the brakes automatically.

Note: When you remove your foot from the brake pedal and press the pedal again when the system is active, you will experience significantly reduced brake pedal travel. This is normal.

Switching the System On and Off

Vehicles with Manual Transmission

You can switch this feature on or off in the information display.

The system remembers the last setting when you start your vehicle.

Vehicles with Automatic Transmission

The system turns on when you switch the ignition on and you cannot switch the system off.

    Hints on Driving With Anti-Lock Brakes. Electric Parking Brake

    Hints on Driving With Anti-Lock Brakes The anti-lock braking system does not eliminate the risks when: You drive too closely to the vehicle in front of you...

    Traction Control

    Principle of Operation The traction control system helps avoid drive wheel spin and loss of traction. If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces engine power at the same time...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Brake Disc Shield. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the brake disc. Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation). Remove the bolts and brake disc shield. Torque: 106 lb...

    Ford Fusion 2013–2020 Owners Manual: Audio Unit - Vehicles With: Sony Audio System/Touchscreen Display


    WARNING: Driving while distracted can result in loss of vehicle control, crash and injury. We strongly recommend that you use extreme caution when using any device that may take your focus off the road. Your primary responsibility is the safe operation of your vehicle...

    Categories

    Fuel Quality

    Choosing the Right Fuel

    Ford Fusion. Fuel Quality

    Your vehicle is designed to operate on regular unleaded gasoline with a minimum pump (R+M)/2 octane rating of 87.

    read more

    Copyright © 2024 www.fofusion2.com