Special Tool(s) /
General Equipment
310-250Disconnect Tool, Fuel LineTKIT-2012A-FLTKIT-2012A-ROW
Disconnect
NOTICE:
When reusing liquid or vapor tube connectors, make sure to
use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the
tube or connector retaining clip can occur...
Other information:
B0004:11, B0004:12, B0004:13 and B0004:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver knee airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver knee airbag
If a fault is detected, the R..
Overview
Multiplexing
is a method of sending 2 or more signals simultaneously over a single
circuit. Multiplexing allows 2 or more electronic modules (nodes) to
communicate over a twisted wire pair [data (+) and data (-)] network.
The information or messages that can be communicated on these wires
consists of commands, status or data. Multiplexing reduces the weight of
the vehicle by reduci..