Ford Fusion: Evaporative Emissions - 1.5L EcoBoost (118kW/160PS) – I4 / Evaporative Emissions. Diagnosis and Testing
Ford Fusion 2013–2020 Service Manual / Powertrain / Engine / Evaporative Emissions - 1.5L EcoBoost (118kW/160PS) – I4 / Evaporative Emissions. Diagnosis and Testing
Engine Diagnostic Information
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
For PCM DTC,
For driveability symptoms without DTC, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 3, Symptom Charts.
Evaporative Emission System Leak Test. General Procedures
Activation
Phase 1 - Leak Verification
Run the EVAP Test with the scan tool.
NOTE:
Some small leaks may not be detected using the EVAP Test...
Other information:
Ford Fusion 2013–2020 Service Manual: Specifications
General Specifications Vehicles with Auto-Start-Stop System Item Specification Voltage 12 V Battery amps rating 70 Ah Cold Cranking Amps (CCA) measured at -18 C (-0...
Ford Fusion 2013–2020 Service Manual: Battery Charging. General Procedures
Charging WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury. NOTE: Batteries will discharge due to normal parasitic key off-loads when the vehicle is on a dealer lot or parked by the customer for an extended period of time...
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Automatic Transmission - 6-Speed Automatic Transmission – 6F35
- Electrical
- Cylinder Head. Removal and Installation
- New on site
- Most important about car
Cross Traffic Alert System Sensors
The sensors are behind the rear bumper on both sides of your vehicle.
Copyright © 2026 www.fofusion2.com