Ford Fusion: Security / Anti-Theft Alarm
The system will warn you of an
unauthorized entry to your vehicle. It will
be triggered if any door, the luggage
compartment or the hood is opened
without using the key, remote control or
keyless entry keypad.
The direction indicators will flash and the
horn will sound if unauthorized entry is
attempted while the alarm is armed.
Take all remote controls to an authorized
dealer if there is any potential alarm
problem with your vehicle.
Arming the Alarm
The alarm is ready to arm when there is
not a key in your vehicle. Electronically lock
your vehicle to arm the alarm.
Disarming the Alarm
Disarm the alarm by any of the following
actions:
- Unlock the doors or luggage
compartment with the remote control
or keyless entry keypad.
- Switch your vehicle on or start your
vehicle.
- Use a key in the driver door to unlock
your vehicle, then switch your vehicle
on within 12 seconds.
Note: Pressing the panic button on the
remote control will stop the horn and signal
indicators, but will not disarm the system.
Note: The system is not compatible with
non-Ford aftermarket remote start systems.
Use of these systems may result in engine
starting problems and a loss of security
protection...
Other information:
Special Tool(s) /
General Equipment
303-1556Locking Tool, Timing BeltTKIT-2010B-FLMTKIT-2010B-ROW
303-748Locking Tool, CrankshaftTKIT-2010B-FLMTKIT-2010B-ROW
Hose Clamp Remover/Installer
4 mm Drill Bit
Removal
NOTE:
The original coolant pump may not be equipped with a clutch and wiring harness connector.
Refer to: Engine Cooling System Health and Safet..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
NOTICE:
Before removing the master cylinder, relieve the
vacuum in the brake booster or the master cylinder O-ring seal may be
drawn into the brake booster, causing brake booster failure and
increased brake pedal effort.
Fully apply and release the brake pedal 5 times.
..