Ford Fusion: Climate Control System - General Information / Air Conditioning (A/C) Compressor Leak Detection - Vehicles With: R1234YF Refrigerant. General Procedures
Special Tool(s) /
General Equipment
Air Conditioning Service Unit |
Electronic Leak Detector |
Air Conditioning Adaptor Kit |
Leak detection
-
Recover the refrigerant. Refer to Air Conditioning (A/C)
System Recovery, Evacuation and Charging procedure in Group 412.
-
Disconnect the refrigerant lines from the A/C compressor. Refer to the appropriate section in Group 412 for the procedure.
-
Install the adapters from the A/C Flush Adapter Kit on the ports of the A/C compressor, using the existing retaining bolts.
-
219-00082 ACF-3000 33PC Adapter Kit - Revised 1st released 44pc kit
-
219-00083 A/C Flushing Adapter Kit 2 of 3 (Previously "Supplement A", 2nd released kit)
-
219-00084 A/C Flushing Adapter Kit 3 of 3
Use the General Equipment: Air Conditioning Adaptor Kit
-
Connect the high and low pressure lines of the air
conditioning service unit to the corresponding fittings on the adapter.
-
199-FFX1234 Flo Dynamics R1234yf A/C Refrigerant Management Center
Use the General Equipment: Air Conditioning Service Unit
-
Charge the A/C
compressor following the air conditioning service unit instructions.
Open the low pressure valve, the high pressure valve and set the
refrigerant charge amount to 0.23 kg (8 oz).
-
NOTE:
Use a Rotunda-approved Electronic Leak Detector for R-1234yf refrigerant SAE Certified to J2913.
Using the Refrigerant Leak Detector, check for leaks at the compressor shaft.
-
023‐22791 Robinair Infrared A/C Refrigerant Leak Detector w/Case
Use the General Equipment: Electronic Leak Detector
-
When the leak test is complete, recover the refrigerant from the compressor.
-
If an external leak is found, install a new A/C compressor.
Special Tool(s) /
General Equipment
412-001
(T71P-19703-B)
Remover, Compressor Pulley
Activation
Remove the A/C compressor. Refer to Air Conditioning A/C Compressor procedure in Group 412...
Special Tool(s) /
General Equipment
A/C Odor Remover Flexible Applicator
Materials
Name
Specification
Motorcraft® A/C Cooling Coil CoatingYN-29
-
Inspection
NOTE:
There are typically 4 types of objectionable odors found in a vehicle:
chemical odors
environmental odors
human and other interior-generated odors
microbiological odors
Befor..
Other information:
Removal
All vehicles
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
Remove the bolts and the lower radiator support.
Torque:
177 lb.in (20 Nm)
If equipped, remove the CCM and bracket.
Refer to: Cruise Cont..
Direction Indicators
Push the lever up or down to use the
direction indicators.
Note: Tap the lever up or down to make the
direction indicators flash three times to
indicate a lane change.
Interior Lamps
The lamps turn on under the following
conditions:
You open any door.
You press a remote control button.
You press the all lamps on button on
the overhead console.
Front Interior Lamp
..