Ford Fusion: Seatbelts / Fastening the Seatbelts
Ford Fusion 2013–2020 Owners Manual / Seatbelts / Fastening the Seatbelts
The front outboard and rear safety restraints in the vehicle are combination lap and shoulder belts.
- Insert the belt tongue into the proper buckle (the buckle closest to the direction the tongue is coming from) until you hear a snap and feel it latch. Make sure that you securely fasten the tongue in the buckle.
- To unfasten, press the release button and remove the tongue from the buckle.
Principle of Operation
WARNING: Always drive and ride
with your seatback upright and the lap
belt snug and low across the hips.
WARNING: Children must always
be properly restrained...
Using Seatbelts During Pregnancy
WARNING: Always ride and drive
with your seatback upright and properly
fasten your seatbelt. Fit the lap portion
of the seatbelt snugly and low across
the hips...
Other information:
Ford Fusion 2013–2020 Service Manual: Front Door Alignment. General Procedures
Adjustment NOTE: Removal steps in this procedure may contain installation details. NOTE: LH shown, RH similar. All alignments Check the body to front door dimensions. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation)...
Ford Fusion 2013–2020 Service Manual: Battery. Removal and Installation
Removal Disconnect the battery cables. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). Remove the battery. Installation To install, reverse the removal procedure...
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Engine
- Pre-Collision Assist (IF EQUIPPED)
- Cylinder Head Temperature (CHT) Sensor. Removal and Installation
- New on site
- Most important about car
Direction Indicators. Interior Lamps
Direction Indicators
Push the lever up or down to use the direction indicators.
Copyright © 2026 www.fofusion2.com