Ford Fusion Manuals

Ford Fusion: Driving Aids / Steering

Electric Power Steering

WARNING: The electric power steering system has diagnostic checks that continuously monitor the system. If a fault is detected, a message displays in the information display. Stop your vehicle as soon as it is safe to do so. Switch the ignition off. After at least 10 seconds, switch the ignition on and watch the information display for a steering system warning message. If a steering system warning message returns, have the system checked as soon as possible.

WARNING: If the system detects an error, you may not feel a difference in the steering, however a serious condition may exist. Have your vehicle checked as soon as possible. Failure to do so may result in loss of steering control.

Your vehicle has an electric power steering system, there is no fluid reservoir, no maintenance is required.

If your vehicle loses electrical power while you are driving, electric power steering assistance is lost. The steering system still operates and you can steer your vehicle manually. Manually steering your vehicle requires more effort.

Extreme continuous steering may increase the effort required for you to steer your vehicle, this increased effort prevents overheating and permanent damage to the steering system. You do not lose the ability to steer your vehicle manually. Typical steering and driving maneuvers allow the system to cool and return to normal operation.

Steering Tips

If the steering wanders or pulls, check for:

  • Correct tire pressures.
  • Uneven tire wear.
  • Loose or worn suspension components.
  • Loose or worn steering components.
  • Improper vehicle alignment.

Note: A high crown in the road or high crosswinds may also make the steering seem to wander or pull.

Adaptive Learning (If Equipped)

The electronic power steering system adaptive learning helps correct road irregularities and improves overall handling and steering feel. It communicates with the brake system to help operate advanced stability control and accident avoidance systems. Additionally, whenever the battery is disconnected or a new battery installed, you must drive your vehicle a short distance before the system relearns the strategy and reactivates all systems.

    Cross Traffic Alert Indicator. Cross Traffic Alert Information Messages

    Cross Traffic Alert Indicator When the system detects an approaching vehicle, a tone sounds, a warning lamp illuminates in the relevant exterior mirror and arrows appear in the information display to show which side the approaching vehicle is coming from...

    Pre-Collision Assist (IF EQUIPPED)

    WARNING: You are responsible for controlling your vehicle at all times. The system is designed to be an aid and does not relieve you of your responsibility to drive with due care and attention...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Wheel Studs. Removal and Installation


    Special Tool(s) / General Equipment Hydraulic Press Removal Remove the front wheel bearing and wheel hub. Refer to: Front Wheel Bearing and Wheel Hub (204-01 Front Suspension, Removal and Installation). Press the wheel stud from the wheel bearing and wheel hub...

    Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: N. Diagnosis and Testing


    B0082:11, B0082:12, B0082:13 and B0082:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seatbelt load limiter circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger seatbelt load limiter If a faul..

    Categories

    Power Door Locks

    The power door lock control is on the driver and front passenger door panels.

    Ford Fusion. Power Door Locks

    Unlock. Lock.

    read more

    Copyright © 2022 www.fofusion2.com