Ford Fusion Manuals

Ford Fusion: Climate Control / Remote Start (IF EQUIPPED)

You can switch this feature on or off and adjust the settings using the information display controls.

The climate control system adjusts the interior temperature during remote start.

You cannot adjust the climate control setting during remote start operation. Switch the ignition on to make adjustments.

Based on your remote start settings, the following vehicle-dependent features may or may not remain on after remote starting your vehicle:

  • Climate controlled seats.
  • Heated steering wheel.
  • Heated mirrors.
  • Heated rear window.
  • Windshield wiper de-icer.

Note: For dual zone climate controlled seats, the passenger seat setting defaults to match the driver seat during remote start.

Automatic Settings

If Auto is on, the system sets the interior temperature to 72°F (22°C) and heats or cools the vehicle interior as required to achieve comfort.

Note: In cold weather, the heated rear window and heated mirrors turn on.

Last Settings

If Last Settings is on, the system uses the settings last selected before you turned off the vehicle.

Heated and Cooled Features

In Auto mode, certain heated features may switch on during cold weather, and cooled features during hot weather.

    Cabin Air Filter. Remote Start

    Cabin Air Filter Your vehicle is equipped with a cabin air filter, which gives you and your passengers the following benefits: It improves your driving comfort by reducing particle concentration...

    Seats

    ..

    Other information:

    Ford Fusion 2013–2020 Service Manual: Information and Entertainment System. Diagnosis and Testing


    DTC Charts ACM DTC Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   DTC Description Action B150C:01 Automobile Audio Bus (A2B) Node 1: General Electrical Failure  ..

    Ford Fusion 2013–2020 Service Manual: Knock Sensor (KS). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove intake manifold. Refer to: Intake Manifold (303-01A Engine - 1.5L EcoBoost (118kW/160PS) – I4, Removal and Installation). NOTE: The head of the KS should not touch any other component. NOTE: The LH KS must be at the 10 o'clock position and the RH KS must be at the 2 o'clock ..

    Categories

    Adjusting the Steering Wheel

    WARNING: Do not adjust the steering wheel when your vehicle is moving.

    Note: Make sure that you are sitting in the correct position.

    Ford Fusion. Adjusting the Steering Wheel

    Unlock the steering column. Adjust the steering wheel to the desired position.

    read more

    Copyright © 2026 www.fofusion2.com