Ford Fusion: Climate Control System - General Information / Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - Overview. Description and Operation

Ford Fusion 2013–2020 Service Manual / Electrical / Climate Control System / Climate Control System - General Information / Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - Overview. Description and Operation

Overview

The Electronic Manual Temperature Control (EMTC) system heats or cools the vehicle depending on the HVAC control panel selection.

The control panel selection determines heating or cooling, air distribution and enables blower motor operation.
The temperature control setting will determine the outlet air temperature.
The blower motor switch varies the blower motor speed.
Vehicles equipped with Auto Start-Stop have a cabin heater coolant pump to help coolant flow to the heater core.
During A/C operation, the system reduces the relative humidity of the air inside the vehicle.

Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - Component Location. Description and Operation

Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 2 IPC 3 GWM 4 Ambient Air Temperature (AAT) sensor 5 PCM 6 A/C pressure transducer 7 A/C clutch relay 8 A/C compressor clutch field coil 9 Externally Controlled Variable Displacement Compressor (EVDC) 10 In-vehicle temperature and humidity sensor 11..

Other information:

Ford Fusion 2013–2020 Service Manual: Brake Master Cylinder. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles NOTICE: Before removing the master cylinder, relieve the vacuum in the brake booster or the master cylinder O-ring seal may be drawn into the brake booster, causing brake booster failure and increased brake pedal effort. Fully apply and release the brake pedal 5 times. ..

Ford Fusion 2013–2020 Service Manual: Brake Caliper. Removal and Installation

Removal NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water. NOTE: Removal steps in this procedure may contain installation details. NOTICE: Brake pads with adhesive on the insulator are one-time use only. When the brake pads a..

Child Safety Locks

When these locks are set, the rear doors cannot be opened from the inside.

Ford Fusion. Child Safety Locks